shankpot12 I'm having the same problem with new 8k 18vr scene. Ive tried a particular video 4 times now and the passthrough has been out of sync every time.

      shankpot12 Yea, I am having to use 5k or even sometimes 4k versions, instead of 6k or 8k, to get them to work correctly.

        doublevr Ok so I just ran a test
        Latency: 136
        Streaming Speed : 135 Mbps
        Parallel streaming speed : 130 Mbps

        The video in question is 68.45 Mbps

        Edit: Woops never mind . My quest got much worse results lol. Now I know. thanks!

            TheStonedPRIEST My quest got much worse results lol.

            Did you run the built-in speed test of DeoVR on your Quest? If so, try some alternative speed test website in the Meta browser. DeoVR speed test results are always around 40 Mbps, no matter what your actual bandwidth is.

            Regarding your original problem: Let's assume for a minute your streaming bandwidth is actually significantly lower than the bitrate of your video. Then I would rather expect that your video plays choppy with a lot of buffering, not just PT being out of sync.

                The bitrate data is helpful... any way to get some sort of auto detect function in the upload interface to warn users? I think the current iteration is assuming the user knows a lot about video/compression etc, which for me was definitely not the case before I started trimming down videos in avidemux.

                I also have a file that says it generated PT but did not load when I tested it. Tried a couple times last night but it never seemed to load any PT, will check again Friday:

                67e2f2592ecd522c8e5d33d4

                  SchnuppiLilac So the the video actually wasn’t choppy at all. It would play just fine in non passthrough. Regardless though, I used hand break to scale it down to 6k and now passthrough works🤷🏼‍♂️