2D / Flat video setting for Quest 3 stored videos

brads75

Is there a way to toggle back to the previous releases' 2D / Flat video viewing settings.

I might be missing a setting somewhere, but every local 2D video on my Quest 3 opens 200%, fully curved, and off-center (way to high).

If I set up the device to actually view these videos, and click the default, I have to re-Zero out the setting when viewing anything in 3D and then start over again if I want to view a 2D local video.

If anything, I would prefer to have settings for each of these types of video (2D and 3D) and use stored defaults for each.

AshSLR

brads75 Hello! Could you please specify what application you use to watch videos and its version? Also, does the issue occur when you try to watch videos downloaded on your device? 🙏

brads75

@AshSLR

I'm using a Quest 3, and DeoVR v: 14.7.3088

Videos downloaded to the quest from anywhere, any resolution (1920 x 1080 for example), open with 200% screen Size, 100% curve, and off center (top to bottom) about 20+ units too high (according to the slider, it says it's at zero for the height, but I have to move it about 23 units in the down direction).

Flat videos streamed directly from SLR loads the same way, 200, 100, and off-center.

I constantly change the settings to 100, 50, and 23-ish

If I change the flat video viewing settings and save this as the new default, it messes up the 3D VR videos settings if I want to stream one of those, and I have to reset transforms to zero to watch the 3D VR video properly, and then start this loop all over again if I want to watch a 2D video.

AshSLR

brads75 Thank you! Does the issue also occur when you are watching other (not flat 2D) videos on SLR online?

brads75

AshSLR
Only if I changed the settings to watch 2D videos before watching 3D videos, then I have to re-Zero the 3D's transform settings.

So it's a constant back and forth. If I re-Zero the 3D settings, I have to re-adjust the 2D settings. It's a ping-pong thing.

That and the 2D "save as Default" button doesn't really work. It just save the height adjustment setting, and not the size and curve settings.

AshSLR

brads75 Thank you for the details! I have forwarded this information to the team 🙏