[deleted]
RealcumberScripts
kiiroo and fleshlight sleeves work with my autoblow with a tiny bit of trimming.
RealcumberScripts
kiiroo and fleshlight sleeves work with my autoblow with a tiny bit of trimming.
From reddit:
"Yeah, it's utterly beyond me how a company can fuck things up like this. This is a 250$ device, and they fail to allow charging while using, and they fail to provide a power adapter variant. It took me a whole 30 mins to add one myself, so yeah would it really have been too much to ask? If you gonna power this thing with a battery, at least install one that lasts for a couple hours...
As for how to add an adapter, it's pretty straightforward. I figured this all out myself and it's the first device I am modding... So be warned.
Open the front-lid... This is pretty easy, it is attached with 6 hooks that are placed equally spaced on the long sides of the panel. So take a thin instrument, like a screwdriver and stick it into the space between panel and case at the middle of the short edge. Slowly move it to the long edge where the first hook is, you can feel it becoming tight. That's where the hook is. Now gently rotate the screwdriver back and forth, like wiggling, until the hook pops out. The other two hooks are easy to undo, other side works exactly the same
Cut the battery off as close to the battery as possible and throw it into the batter disposal.
Get a 15V, 3A (or more) adapter from amazon. Cut the cord to remove the output connector and have a plain raw cable instead.
There is a small "airhole" over the motor opposite to the USB slot. There you can stick through the cable of the power adapter. You may need to gently widen the hole with a screwdriver or drill. The plastic thankfully is flexible and doesn't easily break, but rather falls apart where you drill...
Stick the adapter cord through the hole and then glue black wire to black wire and colored wire to colored wire (might have different colors, the black wire is the important one, only connect black to black). Tape it nicely with isolation tape.
Test the device by pluggin it in and pressing the power button. If should just work...
Now put the buttons back into the case. This is the most fickly part and I had to scream several times, but don't despair, it will work eventuall. The buttons need to be placed in the right orientation and it can take a few attempts to get them both working. Don't press the hooks back in until you are sure both buttons can still be pressed. For that press the case onto the device where the buttons are until they are in the right place and then test them.
Now close the case by pressing in all 6 hooks.
Give it a final spin. Everything should work.
Enjoy UNLIMITED POWER!!!"
I used this power supply kit, which lets you have a plug.
https://www.amazon.com/gp/product/B015H0UPWU/
I run it at 15v. I had read online that the battery is maybe rated higher than that, but if you try to run it at 16v or 17v, it caused the Kiiroo to freak out and shut off.
There are some other write ups online with pictures on how to do it also.
Heresphere recently added support for the Autoblow and its amazing. If they can do it surely you guys are close too
Up for this dev too, i took the sub on SLR and waiting for the autoblow to be implemented for Quest 3.
If anyone needs a temporary solution to Quest 3 and Autoblow Ai:
Download Sidequest : https://sidequestvr.com/setup-howto
Download Haptics Connect: https://apkpure.com/haptics-connect/com.haptics.connect
Download Dexmax: https://m.apkpure.com/dex-max-tweak-for-samsung-de/xyz.masmas.dexmax
Dexmax allows you to run android apps in landscape and resize the window, make sure to grab the corners of the window on the Quest to adjust the size to your liking.
Use sidequest to install on Quest 3, Open Dexmax, open Haptics Connect from within dexmax and you're good to go. It's not immersive or 3D but at least it's in landscape mode and big enough to fill most of your FOV
Another more pain in the ass alternative:
Of course if you want to pause or rewind you're immediately out of sync.
My tips with the autoblow:
-I've been using this stuff and it's been amazing, I tried autoblow's lube and astroglide water based and both got sticky feeling. Also sometimes the lube on the base of your shaft can dry if you're watching a blowjob vid, I recommend keeping a small spray bottle of water to spray a bit on the bottom half if the lube gets sticky.
https://www.toydemon.com/lotions-accessories/lotions/onatsuyu-pussy-juicy-lotion-370ml
Also grabbed this dry stick on a whim and it's made drying SO much easier. You clean the autoblow, put the stick in one end, kinda squeeze and rub between your hands like you're trying to start a fire. Stick it in the other end and do the same and bam it's dry in less than 30 seconds. Although be careful not to drop it it can break.
https://www.toydemon.com/lotions-accessories/cleaners/toydemon-dry-stick
-Only tried the mouth and vaginal sleeves, I prefer the mouth way more.
-For me I pretty quickly noticed for me the faster the thing goes the less stimulating it is, I have a feeling some of the people that I've seen complaining about it are watching scenes where people are getting jackhammered. The problem is the majority of sex vids lean that direction anyways, there arent many slow sex vids, which leads me to my next point...
-Because of the relationship between speed and sensitivity I've found myself watching VRedging videos pretty much exclusively, there are lots of really hot chicks giving very slow, sensual blowjobs.
If you've found yourself disappointed with your autoblow just try one of the slow vids.
Genericinsult
before i buy the app.
so can you watch immersive streaming with the scripts on SLR site and use the autoblow live streaming without sideloading anything to the headset with meta 3?
[deleted] You can't stream SLR with HereSphere, SLR won't let you anymore.
On a side note, HereSphere is worth every penny. It is by far the best player there is. It truly is a next level video player and if you buy it you are supporting a one man show. One guy is somehow years ahead of other players
pyruvatez Have you tried adjusting or completely removing the top cover / cap on the sleeve container? It allows air to pass out of the sleeve so your penis will easily insert.
Play around with adjusting that cover/cap adjusts the amount of suction on your penis to give you that feeling of being sucked off. It's pretty wild.
Praying and hanging tight. SLR integration at full immersion would be incredible with Autoblow AI Ultra.
Can we get an update on this please? The only reason I got a membership is for this integration and if it's not here soon I'm cancelling.
I share the same sentiment. I would like to know aswell so I can resub
It is planned for August release
Kieshi Thanks for the update, any idea for when we can expect it this month
Waiting to pull the pin on a membership for when this is made available
Can’t wait
yeh cant wait
Any further updates ?